Parts List

• 2 x Flush Mount LED Work Lights
• 1 x Wiring Harness
• 8 x Socket head cap screw, M6 – 1.0 x 16mm
• 8 x Flat washer, M6
• 8 x Nylock nut, M6
• 2 x Rubber spacer
• 1 x 5-amp fuse, pre-installed

The Installation Manual

Step 1

Start with marking the ideal place for mounting LED lights. You have to keep a rubber between the light and mounting surface.

In case the light is being used with a 24v system, it must come with a 24v unit.

It’s time to disconnect the supplier switch from the wiring harness. Then you tend to connect it to the required place.

Step 2

You need to install the switch and LED lights. Then make sure to harness the wiring through each light.

On each LED light, insert the male plug into the female socket. It’s time to reconnect the black, blue, and red spade to the switch.

Step 3

With the battery post to the positive side, connect the red fuse wire. Then to the negative pole of the battery, connect the black wire. This could also be done on the suitable grounding point of the vehicle.

Step 4

The providing relay is mounted to the vehicle. To avoid any damage, make sure all wire is connected with zipping. It is good to test the working of lights to check connectivity.

Notes & Maintenance

You need to go through all instructions before installation

All connections and wiring should be properly monitored on a regular basis.

This is done to ensure no loose connection or visible damage to the vehicle light.

Warning

In case of improper installation of electrical devices, injuries could happen. It includes equipment/property damage or personal injury at times.

In case of damage owing to poor installation, insurance won’t accept claims. It is better to hire experts to perform the proper installation to avoid any damage.